Comnet CNGE2FE8MSPOE Technical Information download pdf (Page 53)

6.8 System Event Log

This page allows the user to decide whether to send the system event log, and select the

mode which the system event log will be sent to client only, server only, or both client and

server. What kind of event log will be issued to the client/server depends on the selection on

the Event Configuration tab. There are four types of event—Device Cold Start,

Authentication Failure, X-Ring Topology Change, and Port Event—available to be issued as

the event log.

6.8.1 Syslog Configuration

 Syslog Client Mode: Select the system log mode—Client Only, Server Only, or Both.

‘Client Only’ means the system event log will only be sent to this interface of the switch,

but on the other hand ‘Server Only’ means the system log will only be sent to the remote

system log server with its IP assigned. If the mode is set in ‘Both’, the system event log

will be sent to the remote server and this interface.

 System Log Server IP Address: When the ‘Syslog Mode’ item is set as Server

Only/Both, the user has to assign the system log server IP address to which the log will

be sent.

 Click to refresh the event log displaying area.

 Click to clear all the current event logs.

 Make sure the selected mode is correct, and click to have the setting take effect.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 161 162

No comments

Comnet CNGE2FE8MSPOE Technical Information Page 53